I need to know what type of wrench i need to tighten the dice knobs on my 98 BRian setzer,I can put my finger through theh F hold to hold the bottom of the switch but every wrench I have is to thick to tighten the nut to the body,Thanks for some advice

I think you mean tightening the nuts on the pots. If you don't have a thinner wrench, the knob itself should pull straight off and if not, they may be held on with a set screw. Once the knob is off, tighten the nut like you mentioned by holding the pot from beneath and then put the knob back on. That ought to do it.

It sounds like you're trying to tighten the nut on the potentiometer with knob still in place. If you look at the die, you should find a hole for a small set screw that holds the knob to the shaft of the pot. Loosen it and remove the knob to access the nut on the potentiometer.

What he said...he's younger and types faster ;)

The dice knob has no set screw that I can see,i do not want to force the knob off,its on very tight Thanks for the reply

Check out this pic...the "one" looks to be a set screw.

http://www.guitarpartsresource.com/images/large/006-1.jpg

...and the center of "five."

...and the center of "five."


+1 That's were it is. Hidden very well.:)

Thanks,I just tightend it up its good to go,thank you for your help